A
vehicle Preparation
fahrzeugvorbereitung
Préparation du véhicule
remoVinG The BoDY // aBnehmen Der karoSSerie // DépoSe De la car-
roSSerie // rimozione Della carrozzeria // quiTar la carrocerÍa
Remove the 4 clips and 4 large
screws from the bottom of the side
guards as shown.
Entfernen Sie wie abgebildet die vier
Clips und drehen die vier großen
Schrauben aus den Seitenschützern.
Retirez les 4 clips et les 4 vis des
protections latérales.
Togliere le 4 clips e le 4 viti grandi
dalla parte inferiore del paracolpi
laterale, come illustrato.
Quite los 4 clips y los 4 tornillos
grandes de la parte inferior de los
protectores laterales, como se
muestra.
BaTTerY charGinG WarninGS anD precauTionS
WarNiNG: Failure to exercise caution while using this product and comply with the following warnings could result in product malfunction, electrical
issues, excessive heat, FIRE, and ultimately injury and property
12
damage.
• Read all safety precautions and literature prior to use of
this product.
• Never leave the battery and charger unattended during
use.
• Never allow minors to charge battery packs.
• Always inspect the battery for damage before charging.
• Never attempt to charge dead or damaged batteries.
• Never charge a battery if the cable has been pinched or
shorted.
• Never allow batteries or charger to come into contact
with moisture at any time.
• Never charge batteries in extremely hot or cold
places (recommended between 50–80 degrees
Fahrenheit/10–27 Celsius) or place in direct sunlight.
• Always use only NiMH rechargeable batteries. This
charger cannot charge batteries such as "heavy duty,"
"alkaline battery," or "mercury battery."
Preparazione del veicolo
Preparación del vehículo
• Always connect the positive red lead (+) and negative
black lead (-) terminals of the battery to the charger
terminals correctly.
• Always disconnect the battery and charger after
charging, and let them cool between charges.
• Always terminate all processes and contact Horizon
Hobby if the product malfunctions.
• Always make sure you know the specifications of the
battery to be charged or discharged to ensure it meets
the requirements of this charger.
• Always constantly monitor the temperature of the battery
pack while charging.
• Always end the charging process if the charger or battery
becomes hot to the touch or starts to change form during
the charge process.
Losi 5ive-T • iNsTrucTioN maNuaL