Setting The Switching Period Of The "Incall" Output (7) - Conrad GX101 Notice D'emploi

SMS command: IN1=L or IN2=L
Use SMS command "IN1=L" or "IN2=L" so that input "IN1" (6) or input "IN2" (5) generates and sends
an SMS only when it is low.
To set this response, send an SMS reading "IN1=L" or "IN2=L" (do not enter the quotation marks) to
the SIM card number inserted in the GSM switching module.
SMS command: IN1=0 or IN2=0
Use SMS command "IN1=0" or "IN2=0" so that input "IN1" (6) or input "IN2" (5) generates and sends
an SMS upon every level change.
To set this response, send an SMS reading "IN1=0" or "IN2=0" (do not enter the quotation marks) to
the SIM card number inserted in the GSM switching module.

At a certain level on the optocoupler input, an SMS message is sent to both numbers,
provided 2 numbers have been assigned. See chapter "9.1 Assigning telephone
numbers".

9.3 Setting the switching period of the "INCALL" output (7)


The "INCALL" output (7) is activated when the telephone number of the SIM card
inserted in the GSM switching module is called.
The GSM switching module does not answer incoming calls. No costs are incurred.
The switching period of the "INCALL" output (7) can be specified.
Send an SMS (do not enter the quotation marks) to specify the switching period as follows:
"Anruf=0" Switches the output upon every call (toggle mode)
"Anruf=1" Switching period = 0.3 seconds
"Anruf=2" Switching period = 2.5 seconds
"Anruf=3" Switching period = 10 seconds
"Anruf=4" Switching period = 30 seconds
"Anruf=5" Switching period = 1 minute
"Anruf=6" Switching period = 30 minutes
"Anruf=7" Switching period = 1 hour
"Anruf=8" Switching period = 12 hours
"Anruf=9" Switching period = 24 hours
40