Checking The Charging Station - Mennekes AMTRON Xtra E Instructions D'installation

Masquer les pouces Voir aussi pour AMTRON Xtra E:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 146
1. Tap on "set up manually"
Fig. 30: Entering IP address, Pin and name
2. Enter the IP address and the associated PIN 1 of the
charging station and change the suggested name as
desired.
3. Confirm the entry with "Save".
 The successful set-up is confirmed with a dialogue box.

6.5 Checking the charging station

Warning
Risk of injury
Risk of injury due to damage to the charging station.
If it appears that safe operation of the charging station is
not possible:
 Put the charging station out of service.
 Determine and eliminate any faults / malfunctions.
 See Chapter 9 "Troubleshooting" on page 42.
Inspection in accordance with DIN VDE 0100 or
national regulations
Carry out an inspection of the charging station in
accordance with DIN VDE 0100 or the applicable national
regulations prior to the initial setting-up process and
according to the specified maintenance intervals.
System check
A test box is required for a systems check. The test box
simulates the communication with the vehicle.
Test boxes are available from MENNEKES.
 See Chapter 11.1 "Accesories" on page 46.
Carry out a system check with a test box before approving
the charging station for use.
 Carry out the system check according to the
documentation of the test box.
28

Publicité

Table des Matières
loading

Table des Matières