Installation; Choice Of Location; Unpacking - Mennekes AMTRON Xtra E Instructions D'installation

5 Installation

Danger
Mortal danger posed by improper installation.
There is a risk of injury for persons performing tasks for
which they are neither qualified nor have received
appropriate training.
 The device may only be installed by persons who are
familiar with this task, have been instructed with
regard to the associated hazards and who possess the
necessary qualifications.
 Before installing, all safety requirements must first be
met.

5.1 Choice of location

Warning
Risk due to unsuitable environmental conditions /
installation locations.
Unsuitable ambient conditions and installation locations
may lead to dangerous situations when dealing with
electricity.
Please observe the following points when selecting an
installation location:
 Do not install in potentially explosive atmospheres (e.g.
gas refuelling stations).
 Do not install in flood-prone areas.
 Comply with local technical connection requirements
and safety rules.
 For ambient conditions, see Chapter 4.2 "Ambient
conditions" on page 11.
 The charging system must be protected from direct
exposure to water jets.
 The mounting surface must have sufficient strength to
withstand the mechanical stresses. When mounting on
plasterboard walls they must have at least two layers.

5.2 Unpacking

Caution
Damage to the charging station by improper
handling.
Collisions and impacts may damage the charging station.
 Move the charging station with utmost caution.
 Use a soft base to set aside the charging station.
Fig. 10: Unpacking
Unpacking the charging station:
1. Remove the charging station
from cardboard box.
2. Place the charging station on a soft base.
1 and the drilling jig 2
12