6.3.3 Calling up the service interface
Follow these steps to access the service interface:
1. Enter IP address and port number in the address bar of
your Internet browser (http://AMTRONIP: 25000).
2. Enter PIN 3 (installation PIN, see set-up data sheet) of
the charging station.
3. The main menu of the service interface opens.
Fig. 18: Main menu
4. Select the submenu "Installation Settings". The menu
"Installation Settings" shows the settings required for
the setting-up process.
Fig. 19: Menu "Installation Settings"
5. Carry out the configuration considering the upstream
safety devices.
See Chapter 5.4 "Electrical connection" on page 15.
6. Save the new configuration by clicking on the
"Submit" button.
6.3.4 Setting up a direct connection (access point
mode)
Carry out the following steps to establish a direct
connection to the charging station with a tablet / smart
phone.
If the charging station is already connected to a home
network, a direct connection over WLAN is not possible.
1. Open the WLAN settings of your tablet / smart phone
and search for available wireless networks
2. Select the desired network AMTRON
The name is composed of the product name and the
MAC address of the charging station, e.g.
AMTRON_7C70BCxxx.
3. Enter the WPA2 key of the AMTRON WLAN (see set-up
data sheet) and connect to the network.
4. Open the MENNEKES charge app and search for
charging stations.
5. Select the desired charging station by the serial number
(SNR, see set-up data sheet).
6. Enter PIN 1 (APP PIN, see set-up data sheet).
7. Assign a name to the charging station and confirm your
entry with "Save".
Make sure that the spelling is correct when entering the
WLAN network name (SSID) and WLAN key (WPA key).
Entries are case-sensitive. The special character " is not
allowed.
1)
For tablets / smart phone with Android operating system, you may
need to disable the mobile network data services.
1)
.
®
charging station.
20