Interior View - Mennekes AMTRON Xtra E Instructions D'installation

Fig. 5: Rear view (example)
Rear enclosure part
1
Fastening screws for front
2
enclosure part
Air outlet
3
The enclosure of the charging station has three parts and
consists of rear enclosure part, front enclosure part and the
front panel.
The front panel has to be folded down to access the internal
components. The design of the front panel depends on the
version of the charging station.
 See Chapter 3.6.1 "Front panel" on page 9.
Opening for cable duct
4
Fastening holes
5
Cable glands
6

3.5.2 Interior view

Fig. 6: Interior view of rear enclosure part (example)
1 Counter
2 Circuit breaker (CB)
3 Multi-function actuator
4 Charging contactor
5 System monitoring
6 Cable glands
The charging station contains all required components for
controlling the charging process and communicating with
the vehicle.
The design of the components depends on the version of
the charging station.
7 Controller (HC controller)
8 Residual current circuit
breaker (RCCB)
9 Mains adapter
j Terminals for mains
connection
8