Mennekes AMTRON Xtra E Instructions D'installation page 73

Menu "Customer Settings"
Fig. 24: Menu "Customer Settings"
The menu "Customer Settings" can be used to make
customer specific settings. Changes take effect by clicking
on the button "Submit".
Value Description
AMTRON
Setting the limit of the maximum
Customer
available charging current in A.
Current
Limitation
AMTRON Setting the device name. The device
Wallbox name is displayed in the Charge APP and
Name the service interface.
Enable RFID Enable / disable RFID card reader.
Authorisation  RFID card reader enabled
 RFID card reader disabled
Value Description
Power Fail Enable / disable continue charging
Continue process after power failure
 The charging process continues
after a power failure
 A power failure terminates the
charging process
Autostart Enable / disable autostart of charging
Charging process
 The charging process starts
automatically when connected to a
vehicle.
 The charging process must be
started manually when connected
to a vehicle.
This setting will be ignored with
RFID card reader enabled.
Enable Stop Enable / disable stop button.
Button  Stop button enabled
 Stop button disabled
Color Schema Setting the colour scheme of LED info
bar
Enable RFID
Enable / disable audible feedback of
Beep
the RFID card reader.
 Audible feedback enabled
 Audible feedback disabled
Enable WLAN Enable / disable WLAN module.
Communication  WLAN module enabled
 WLAN module disabled
AMTRON Selecting the operating mode of the
Operation charging station.
Mode
 See Chapter 7.4 "Description of
operating modes" on page 32.
24