Regulations; Assistance; Risk Prevention - SOMFY Dexxo Compact RTS Manuel D'installation

Dexxo Compact RTS
> Safety devices
For operation in automatic mode or remote control,
photoelectric cells must be installed.
In automatic mode, the drive operates in at least one
direction with no intentional activation by the user.
For operation in automatic mode or if the garage door faces
a public road, installation of an orange light may be required
to comply with the regulations in the country in which the
drive is installed.
> Clothing precautions
Take off any jewellery (bracelet, chain, etc.) during
installation.
For manoeuvring, drilling and welding operations, wear
appropriate protection (special glasses, gloves, ear
protection, etc.).

1.6 Regulations

Somfy SAS declares that the product described in
these instructions, when used in accordance with these
instructions, complies with the essential requirements of the
applicable European Directives and, in particular, with the
Machinery Directive 2006/42/EC and the Radio Equipment
Directive 2014/53/EU.
The full text of the EC declaration of conformity is available
on the following website: www.somfy.com/ce. Antoine
CREZE, Head of Regulations, Cluses

1.7 Assistance

You may encounter difficulties or have questions when
installing your drive.
Do not hesitate to contact us; our specialists are on hand to
answer all your questions.
Internet: www.somfy.com

1.8 Risk prevention

Risk prevention - motorisation of sectional/up and
over garage door for residential usage
Zone 4
Zone 5
Zone 3
Zone 4
3
WARNING
WARNING
Zone 2
Zone 1
Zone 3
Zone 1
Zone 4
Risk zones: measures to be taken to eliminate risks.
RISK SOLUTION
ZONE 1 Obstacle detection built into the
drive.
Risk of crushing
between the ground Obstacle detection must be
and the lower edge confirmed as being compliant
of the door during with Appendix A of standard EN
closing 12 453
For operation with automatic
closing, install photoelectric cells
ZONE 2 Obstacle detection built into the
drive.
Risk of crushing
between the lintel and Obstacle detection must be
the upper edge of the confirmed as being compliant
door during closing with Appendix A of standard EN
12 453
ZONE 3 Eliminate all sticking points and
all sharp edges from the surface
Risk of cutting or
of the door
trapping between the
door panels in gaps Eliminate any gap ≥ 8 mm or ≤
of between 8mm and 25 mm
25mm
ZONE 4 Eliminate all sharp edges on the
guide rails
Risk of trapping
between the roller rails Eliminate any gap ≥ 8 mm
and bearings between the rails and the
bearings
ZONE 5 Obstacle detection built into the
drive.
Risk of crushing
between the secondary Obstacle detection must be
edges and adjoining confirmed as being compliant
fixed parts with Appendix A of standard EN
12 453
Zone 2
Zone 5
Copyright © 2015 Somfy SAS. All rights reserved