Electrical Installation; Safety Instructions Relating To Installation; Clothing Precautions; Regulations - SOMFY DEXXO SMART io Manuel D'installation

DEXXO SMART io
Figure 1 - Mechanical protection
Figure 2 - Safety distances

1.5. Electrical installation

DANGER
The installation of the power supply must comply
with the standards in force in the country in which the
motorisation is installed, and must be carried out by
qualified personnel.
The electric line must be exclusively reserved for the
motorisation and equipped with protection, comprising:
• a 10 A fuse or breaker,
• a differential type device (30 mA).
An all-pole power supply cut-off device must be provided.
It is recommended that you fit a lightning conductor
(maximum residual voltage 2 kV).
Cable feed
Underground cables must be equipped with a protective
sheath with a sufficient diameter to contain the motor cable
and the accessories cables.
For overground cables, use a cable grommet that will
withstand the weight of vehicles (ref. 2400484).

1.6. Safety instructions relating to installation

WARNING
Before installing the motorisation, remove any
unnecessary cords or chains and deactivate any locking
device (bolt) which is not required for motorised operation.
DANGER
Do not connect the motorisation to a power source before
installation is complete.
©
Copyright 2018 SOMFY ACTIVITES SA. All rights reserved.
WARNING
Modifying any of the components in this kit or using
additional components not recommended in this manual
is strictly prohibited.
Monitor the door as it moves and keep people away from it
until installation is complete.
Do not use adhesive to secure the motorisation.
Install the internal manual back release device at a height of
less than 1.8 m.
Permanently affix the label concerning the manual back
release device near to its mobile component.
WARNING
Take care when using the manual back release device as
an open door can suddenly fall off if the springs are weak,
broken, or incorrectly balanced.
ATTENTION
Install any fixed control device at a height of less than 1.5 m
and within sight of the door, but away from moving parts.
A er installation, ensure that:
• the mechanism is correctly adjusted
• the manual back release device is operating correctly
• the motorisation changes direction when the door
encounters an object 50 mm high on the ground.

Clothing precautions

Take off any jewellery (bracelet, chain, etc.) during installation.
For manoeuvring, drilling and welding operations, wear
appropriate protection (special glasses, gloves, ear protection,
etc.).

1.7. Regulations

Somfy declares that, when used in accordance with these
instructions, the product described in these instructions
complies with the essential requirements of the applicable
European Directives, and in particular Machinery Directive
2006/42/EC and Radio Equipment Directive 2014/53/EU.
The full text of the EC declaration of conformity is available at
the following website: www.somfy.com/ce.
Antoine CREZE, Head of Regulations, Cluses

1.8. Assistance

You may encounter difficulties or have questions when
installing your motorisation.
Do not hesitate to contact us; our specialists are on hand to
answer all your questions.
Internet: www.somfy.com
EN
3