Connecting The Pump Set To The Pump Housing - Medela Symphony Série Mode D'emploi

NOTICE
• Use Medela original accessories only.
• Refer to instructions for use provided with the Symphony pump set for description and
instruction on handling the pump set.
• Check pump set parts for wear or damage before use. Replace damaged or worn parts.
• All parts must be completely dry before use.

5.5 Connecting the pump set to the pump housing

1. Carefully assemble the Symphony pump set according
to the instructions for use provided with the pump set.
2. Screw a bottle into the connector. Use a bottle according
to the individual needs (various bottle sizes available).
1. Open the lid of the breast pump: Press the oval button
on the top of the Symphony pump and lift the handle.
2. Position the Symphony cap firmly on the breast pump
membrane to form a seal.
Æ Make sure that the Symphony cap engages and lies
flush to the surface.
3. Centre the tubing connector in the recess in the pump
housing.
i
Information
Always close the lid when pumping. The lid keeps the
membrane cap pushed down to prevent a loss of vacuum
that could occur if the membrane cap came off.
4. Close the lid.
17