Error Codes - Medela Symphony Série Mode D'emploi

Troubleshooting and error codes (cont.)

8.2 Error codes

28
The following table describes error codes that may be displayed indicating an issue with
the unit, potential causes, and steps to correct the issue.
Display
Invalid card
No card
Battery low
Motor
overload
Error
Power fault
Potential issues
Program card is not a Symphony
card
Program was inserted incorrectly
Program card is damaged and
not working
Program card is not inserted
Program card is not completely
inserted
Battery needs charging soon, will
beep every 20 seconds (15 minutes
of pumping time remaining from
when the indication started)
Motor is drawing too much current
Potential fault in electronics
of gear control
Potential fault in electronics
of power supply
Actions
• Check if the correct program
card is being used
• Make sure that the card
is positioned correctly
• Replace program card
• Insert program card
• Push card all the way in
• Make sure that the power cord
is plugged into the back of the
pump
• Contact your local Medela
representative if this happens
repeatedly
• Contact your local Medela
representative if this happens
repeatedly
• Contact your local Medela
representative if this happens
repeatedly