Use - Cleanmaxx 01378 Mode D'emploi

EN

Use

Read the safety instructions prior to use!
Cleaning the Floor
PLEASE NOTE!
■ To use the device on laminate fl ooring, the following must be ensured:
– The laminate must be properly laid and have no gaps or cracks into which mois-
ture could penetrate.
– Test the device fi rst on an inconspicuous spot. Then check it for any waves or in-
gress of moisture. If the test spot is unblemished, the device can be used to clean
the entire laminate fl oor.
■ Before using the device, always check the fl oor cloth for signs of wear. A fl oor cloth
that is worn or has holes in it must not be used. The fl ooring could be damaged.
■ If the device is parked after use, a wet spot may form beneath the cleaning foot.
With sensitive fl oors, a cloth should therefore be placed beneath the cleaning foot or
parking for a prolonged period of time should be avoided.
1. Give the fl oor a general sweep or vacuum before using the device.
2. Attach the stem (N) with stem handle (B) and the cleaning foot (M) with fl oor cloth (L)
to the main unit (A). If a carpet is to be cleaned, use the carpet glider (K) (see "As-
sembling the Device").
3. Fill the water tank (3) with water (see "Filling the Water Tank").
4. Unwind the mains cable (10). To do this, turn down the upper hook for winding up
the cable (13).
5. Stand the device upright. The joint (7) of the cleaning foot locks in place in a vertical
position.
6. Insert the mains plug into a properly installed plug socket that is easily accessible.
7. To switch on the device, press the
8. Use the wheel for setting the steam power (4) to set the steam power you want. De-
pending on the setting, one of the two lights (5) switches on (
lot of steam).
9. The heat control lamp on the wheel for setting the steam power lights up red during
the heating process. Once the operating temperature has been reached, the colour
changes to blue. The device then starts to emit steam automatically. You can now
start cleaning the fl oor.
10. Hold the device by the stem handle and lower the main unit slightly towards the fl oor
to release the locked standing position. Then slide the cleaning foot slowly across
the fl oor. The fl oor is cleaned as you do this.
11. If the device makes pumping / humming noises, there is not enough water in the wa-
ter tank. It needs to be topped up. Switch off the device before topping it up (
the On / Off switch) and pull the mains plug from the plug socket.
12. After use, follow the instructions in the "After Use" section.
01378_de-en-fr-nl_A5_V1.indb 24 01378_de-en-fr-nl_A5_V1.indb 24
24
On / Off switch (9).
little steam / a
press
10.11.2017 12:20:12 10.11.2017 12:20:12