Component Overview; Left End Plate - Aventics CD01-PI Notice D'instruction

62 AVENTICS | CD01-PI | R412012449–BAL–001–AD
Device Description
5.1

Component overview

You can find the material numbers of the individual components
in your configuration in the AVENTICS Internet configurator
under your material number.
Protective caps for sealing electrical contacts must be included
when ordering blanking or supply plates.
Protective cap R412005856 must be ordered separately to seal
the electrical contacts. The remaining seals and screws
required for assembly are included in the delivery scope.
5.1.1

Left end plate

The left end plate contains all VS pneumatic connections.
Depending on the configuration, the assembled plug box
includes the following electrical connections:
D-Sub plug, 25-pin
D-Sub plug, 37-pin
CNOMO connection M23, 19-pin
Changing from a multipole to fieldbus version is possible (see
section 6.5.3 "Connecting the bus coupler" on page 78).
The valve coils are controlled via the multipole connection or
bus coupler. The connections are run from the plug box or bus
coupler pins over the left end plate through a cascade plug-in
system to base plates and assigned to the respective coils.