Aventics CD01-PI Notice D'instruction page 59

AVENTICS | CD01-PI | R412012449–BAL–001–AD 59
For your safety
Only use a power pack with secure isolation to
DIN EN 61558-1 from 2006 and DIN EN 61558-2-6 from
1998 (UL Class 2 Supply only).
Please always observe the respective national regulations.
On installation Make sure the relevant system component is not under
pressure or voltage before assembling or when connecting
and disconnecting plugs. Protect the system against being
switched on.
Lay the cables so that no one can trip over them.
Only use pre-assembled and tested plugs and cables, thus
avoiding voltage reversal.
During commissioning Let the product acclimatize for several hours before
commissioning, otherwise, water may condense in the
housing.
The device complies with protection class IP 65 and NEMA 4.
Before commissioning, make sure that all the connection
seals and plugs are tight to prevent fluids and foreign bodies
from penetrating the device.
Ensure that the power supply is within the stipulated
tolerance for the valves.
Only commission fully installed VS.
During operation Fit exhaust air connections that are not connected to an
exhaust air line with a silencer.
During cleaning Never use aggressive solvents or detergents. Only clean
the device using a slightly damp cloth. Only use water and,
if necessary, a mild detergent.
Disposal Dispose of the device in accordance with the currently
applicable regulations in your country.