Safety Instructions For Operators - Güde GFO 1401 Mode D'emploi

Linear cuts

Set the parallel ruler towards the saw blade
to get required width.

Put the workpiece on the table, flat resp.
wider side down.
Attention: keep adequate safety distance
form the saw blade.
Producing Bevelcuts

Fix the workpiece with the clamp as shown.

Loose the adjustment lever and set the
angle required.

Confirm the holing prop is in the saw line.

Fasten up the adjustment screw. Turn the
tool on and press the saw down to carry out
required cut.
Producing Crosscuts
 Adjust the cross fence into one of two
grooves on the table and set the angle
required.
 Turn the tool on and with the cross fence
slide it slowly towards the running saw.
Attention: Hold the carried workpiece
firmly but never the part which is going to be cut
off.
Holing prop setting (pict. 17+25)

Loose the bolt on holing prop (pict.25) to let it
shift – see relevant cut.

Tight the bolt back up
Maximum cuts:
The distance between the saw table and the
upper edge of holing prop is about 10cm.
Chips suction
If running the tool in confined places, it is needed
to use proper suction unit or the dust bag, which
is part of the delivery, must be put on the outlet
nozzle (pict. 31)

Safety instructions for operators


All protective and safety equipment must be
mounted properly and in place before
running the tool.

Never cut such a wood pieces that cannot be
fixed safely.

Saw blade must rotate freely.

If cutting already processed wood, watch out
for nails, bolts etc. Remove all objects before
work.

Confirm before pressing the main switch that
the saw blade is mounted correctly and all
moving parts are oving freely.

If any doubts seek qualified advice at
authorized Service center.

Read the instruction manual carefully before
operation.

Observe all safety precautions stated in the
manual.

Be responsible towards other people.
How to proceed step by step
Desktop saw
1. set the rulers and fences according to
required cut.
2. turn the tool on.
3. slide the workpiece slowly under the saw
blade until the cut is finished.
4. turn the saw off and wait until the blade stops
completely.
5. now remove the workpiece.
Bevel and miter saw
1. carry out above stated adjustments on the
tool according to required cut.
2. fix the workpiece with designed
clamp.(pict.1/7).
3. turn the tool on.
4. press the saw slowly down to execute the
cut.
5. turn the saw off and wait until the blade stops
completely.
6. now remove the workpiece.
Malfunctions-causes-elimination
Attention: first of all check the overcurrent
fusses!
Motor is not running
1. The tool is without power
Check electric distribution and power cord,
seek qualified advice.
2. Heat sensor cut the power off
Wait 5 to 10sec. and then turn the tool on
again.
Motor went off during the work
1. heat sensor is defective. Have it replaced by
an electrician expert.
2. motor safeguard turns it off from some
reason.
12