Symbols Explanation - Güde GFO 1401 Mode D'emploi

Symbols explanation

There are used following symbols in this
instruction manual and on the tool:
Product safety:
This product complies with
corresponding standards of EC
Restrictions:
Overall restriction
(in connection with other
pictogram)
Cautions:
Caution/Attention
Orders:
Use eye protection
Read the instruction manual before
use
Use safety gloves
Environment:
Don't litter, dispose the waste
correctly
Damaged and liquidated electric or
electronic devices has to be
handed over in designated places
for recycling.
Wrapping
protect from wet
Tool is provided with protective
insulation
Don't touch rotating parts
Warning high voltage
Use ear protection
Use head protection
Cardboard wrapping can be
disposed in designated places
only.
Green point dual system in
Germany (Duales System
Deutschland AG)
This face up
Technical data:
Power plug
Revolutins
Noise level
Cutting depth at 45°
Purpose
Bevel slide miter saw is suitable for linear, cross
miter and bevel cutting of wood and soft platic.
Logs (pipes and timber in the round) are strictly
prohibited to cut on this tool. The same with
metal materials.
Failure to observe the safety rules stated in this
Instruction manual and other basic stipulations in
force cannot lead into the responsibility of the
manufacturer for any damage that might occure
from above mentioned.
Meaning of terms

Saw spindle
it is a spindle where the saw blade is fixed
to.

Crosscuts
Cut across the fibres

Sloping cut
Procedure when the cut is not done
perpendicularly towards the surface of a
workpiece.

Bevel cuts
Procedure when the cut is not done
perpendicularly towards the front of a
workpiece

Double bevel cut
Combination of a beveled and sloping cut

Revolutins per minute
Number of revolutions that an object makes
in one minute.

Cut line
Area of a workpiece or table which is
directly in line of the saw blade cut even
that part of a workpiece that was already
saw up.

Rake
Extent of how much the bent saw tooth
laps over the blade edge.

Sawn joint
Joint made while removing the material by
rotating saw blade.
9
Motor power source
Saw blade
Cutting depth at 90°
Weight