Cleanmaxx 00877 Mode D'emploi page 24

EN
24
Cleaning the Filter and the Dust Container
1. Empty the dust container (18) (see above). Do not close the bottom fl ap (24).
2. Reach into the dust container. Turn the fi lter holder (17) a little until it is released and
can be removed.
25
7. Let all parts dry completely in the air before you reassemble them. NOTICE: Never
assemble wet or damp components or attach them to the motor unit (14)! The
device is assembled in the reverse order.
Cleaning the Motor Unit, Extension Tube and Nozzles
• Wipe down the motor unit (14), extension tube (6) and nozzles with a damp, soft cloth
if necessary. Then dry them with a soft cloth.
• Regularly remove hair and fl uff from the nozzles and brushes.
Cleaning the Turbo Nozzle
To make it easier to clean, the brush can be removed from the turbo nozzle (9):
Storage
• Store the device in a cool, dry place which is protected from direct sunlight and is out
of the reach of children and animals.
• For easy storage, attach on the wall bracket which is supplied.
3. Pull the catch of the bottom fl ap (24) away from the dust
container slightly. The bottom fl ap will open and the dirt
will fall out.
4. To close it, press the bottom fl ap onto the dust container.
The catch must be heard to engage in place.
3. Pull the HEPA fi lter (25) out of the fi lter holder.
4. Tap out both parts and clean them with a soft brush if
17 necessary.
5. The fi lter holder can also be rinsed with clear water. NO-
TICE: Do not wet-clean the HEPA fi lter!
6. Wipe out the dust container with a damp cloth if neces-
sary.
1. Slide the latch fastener on the bottom of the turbo nozzle
towards the small wheel on the turbo nozzle.
2. Open the latch.
3. Take out the brush and remove any contamination.
4. Reinsert the brush. When you do this, fi rst insert the end
with the star-shaped recess.
5. Close the latch and slide the latch fastener back in place.
24