Assembly; Attaching / Removing Nozzles; Removing / Inserting The Dust Container; Use - Cleanmaxx 00877 Mode D'emploi

EN

Assembly

Attaching / Removing Nozzles

With the exception of the turbo nozzle (9), all nozzles are attached with the aid of the
nozzle adapter (7).
• Plug the nozzle adapter into the suction opening (19) or the extension tube (6). Plug
the nozzle you want onto the nozzle adapter.
• To take them apart, pull the nozzle and the adapter apart.
Attaching / Removing the Turbo Nozzle and Extension Tube
No adapter is required for the turbo nozzle (9) and the extension tube (6).
• They are plugged directly onto the suction opening (19). The catches must be heard
to engage in place. Attach the turbo nozzle to the extension tube in the same way.

Removing / Inserting the Dust Container

closed
open

Use

NOTE!
■ Only switch on the device once you have made sure that the dust container and the
fi lter are inserted correctly.
■ Do not suck up any animals with the device. They could become stuck to the device/
injured. Should the device become stuck, switch it off immediately.
■ Always switch off the device before replacing any accessories.
■ Empty the dust container after every use, or when it is full up to the MAX marking, to
maintain good performance and prevent overheating of the motor (see the "Cleaning
and Storing the Device" chapter). The fi lter must also be cleaned regularly to prevent
the motor from being overloaded.
■ Switch the device off after each surface has been cleaned as this will considerably
increase the operating time on each battery charge. Charge up the battery after use
(see the "Charging Up the Battery" chapter).
22
• To detach it, press the release button (10) and pull the
turbo nozzle or the extension tube out at the same time.
• Removing: Twist the dust container (18) a little bit. It is re-
leased from the motor unit (14) and can be removed.
• Inserting: Insert the dust container into the motor unit. Ro-
tate it slightly as you do this until it engages in the motor unit
correctly. Then twist the dust container in the motor unit to
secure it in place. The release button of the dust container
must be located below the suction opening (19) after it has
been attached.