Before Initial Use; Assembly; Attaching / Removing Nozzles - Cleanmaxx LD-622 Mode D'emploi

Before Initial Use

PLEASE NOTE!
■ Never remove the rating plate and any possible warnings!
• Before using the device, remove all packaging materials and any labels that may be
on the device and are used for protection during transportation or for advertising.
Please note that there may be dirt residues in the dust container or in the fi lters.
These residues can be attributed to quality checks and do not constitute a defect
with the device.

Assembly

PLEASE NOTE!
■ Switch off the device before a nozzle is replaced.
Inserting / Removing the Hose
Inserting / Removing the Telescopic Tube
Adjusting the Length of the Telescopic Tube
A

Attaching / Removing Nozzles

• Plug the free end of the telescopic tube as far as it will go into one of the nozzles
supplied. Twist the nozzle back and forth slightly as you do this.
• For greater fl exibility, the nozzles can also be plugged directly onto the handle of the
suction hose, without the telescopic tube.
• To detach a nozzle, pull it off.
19
• Plug the connection piece of the suction hose into the suc-
tion intake opening on the dust container and twist it clock-
wise a little. It must engage audibly.
• To detach the suction hose, twist the connection piece an-
ticlockwise a little and pull out the suction hose.
• Plug the handle into the appropriate opening of the tele-
scopic tube. Twist the handle back and forth slightly as you
do this. Then check the connection to make sure there is a
secure fi t.
• To detach the telescopic tube, pull it away from the handle.
• Push the slider (A) on the telescopic tube downwards and
pull the telescopic tube out to the length you want.
• Release the slider and move the telescopic tube a little bit
more until it engages.
EN