Airflow Direction Control - Whirlpool AMD 385 Mode D'emploi

AIRFLOW DIRECTION CONTROL

5. Airflow direction control
The louver is automatically adjusted to a certain
angle in accordance with the operation mode after
turning on the unit.
The direction of airflow can be also adjusted to
your own requirement by pressing the "SWING"
button of the remote control.
Operation mode
COOLING, DRY
*HEATING, FAN ONLY
*Heating mode is only available for heat pump
models.
Louver control (using the remote control)
Use the remote control to set the flow angles.
Swinging airflow
Pressing "SWING" button once, the louver will
swing up and down automatically.
Desired direction airflow
Pressing the "SWING" button again when the
louvers swing to a suitable angle as desired.
Note:
A - Do not turn the louvers manually, otherwise
malfunction may occur. If that happens, turn
off the unit first and cut off the power supply,
then restore power supply again.
B - It is better not to let the louver tilt downward
for a long time at COOLING or DRY mode to
prevent condensed water from dripping.
Direction of airflow
horizontal
downward
13