Whirlpool AMD 385 Mode D'emploi page 24

2. Ensure good ventilation of outdoor unit;
3. There should be no obstacles near the outdoor
unit obstructing the air intake and air exhaust of
the unit;
4. The installation position shall be able to
withstand the weight and vibration of the
outdoor unit and ensure safe installation;
5. Select a dry place but not exposed to direct
sunshine or strong wind;
6. Ensure that the outdoor unit is installed in
compliance with installation dimensions for easy
repair and maintenance;
ELECTRICAL SAFETY REQUIREMENTS
1. The power supply must be of rated voltage
with special circuitry for the appliance. The
normal operating range of voltage is
90%~110% of rated voltage. The diameter of
the power cord must comply with
requirements.
2. The user power supply shall have a reliable
grounding terminal. It is prohibited to connect
the grounding wire to the following items:
1) Water Supply Pipe 2) Gas Pipe 3) Sewage
Pipe 4) Other positions that are considered
unsafe
3. Ensure safe grounding and a grounding wire
connected with the special grounding system
of the building, installed by professionals. The
appliance must be fitted with electrical leakage
protection switch and an air switch with
sufficient capacity (Refer to the following
chart). The air switch must also have a
magnetic and a thermal tripping function to
ensure protection in case of short-circuit and
overload.
Type Model
AMD 385
Inverter
AMD 386
Required Capacity of
air break switch
32A
32A
7. Height difference of fitting pipes shall be within
5 meters and the length of fitting pipe shall be
within 10 meters;
8. Install the unit out of the reach of children;
9. Choose a place that does not interfere with
public passage or view.
4. Make sure that the power supply cord is long
enough to allow the right connection. Do not
use any extension cord for power supply.
5. If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person in order to
avoid a hazard;
6. An all-pole disconnection switch having a
contact separation of at least 3mm in all poles
should be connected in fixed wiring.
7. Risk of electric shock can cause injury or
death: Disconnect all electric power supplies
before servicing.
8. The connection of power cord and the cable
connection between indoor unit and outdoor
unit shall be in accordance with the wiring
diagram attached on the appliance.
9. Once installation is completed, the electric
components must not be accessible to the
users.
10. Use two or more people to move and install
the appliance to avoid excessive weight hazard.
11. After unpacking the air conditioner, keep all
packaging materials well out of the reach of
children.
12. According to the character of refrigerant
(R410a), the pressure of the tube is very high,
so be sure to careful when you install and
repair the appliance.
24