Airflow Direction Control - Whirlpool SPOW 407 Mode D'emploi

AIRFLOW DIRECTION CONTROL

5. Airflow direction control
Horizontal airflow is automatically adjusted to a
certain angle in accordance with the operation
mode after turning on the unit.
The direction of airflow can be also adjusted to
your own requirement by pressing the "SWING"
button of the remote control.
Operation mode
COOLING, DRY
*HEATING, FAN ONLY
*Heating mode is only available for heat pump
models.
Horizontal airflow control (using the remote
control)
Use the remote control to set the flow angles.
Swinging airflow
Pressing "SWING" button once, the horizontal
adjustment louver will swing up and down
automatically.
Desired direction airflow
Pressing the "SWING" button again to hold the
horizontal adjustment louver when the louvers
swing to a suitable angle as desired.
Vertical airflow control (by hands)
Turn the control rods of the vertical adjustment
louvers to change vertical air flow as shown.
Note: The shape of the unit may look different
from that of the air conditioner you have selected.
A - Do not turn the horizontal adjustment louvers
manually, otherwise malfunction may occur. If
that happens, turn off the unit first and cut off
the power supply, then restore power supply
again.
B - It is better not to let the horizontal adjustment
louver tilt downward for a long time at
COOLING or DRY mode to prevent
condensed water from dripping.
Direction of airflow
horizontal
downward
control rod of vertical
adjustment louvers
11