Changing Air Direction; Normal Sounds; Air Conditioner Care; Cleaning The Air Filter - Whirlpool 819041994 Guide D'utilisation

To set Timer for a 0.5- to 24-hour delay before air
conditioner turns Off (air conditioner must be ON):
1. Press TIMER. Timer indicator light on air conditioner will
flash. Display on air conditioner will show remaining hours
before air conditioner will turn off.
2. Press the plus or minus pad to change the delay time (0.5 to
24 hours).
3. Press TIMER again or wait 10 seconds. Timer indicator light
on air conditioner will remain on.
To set Timer to turn on air conditioner, keeping previous
settings:
1. Turn off air conditioner.
2. Press TIMER. Timer indicator light on air conditioner will
flash. Display on air conditioner will show remaining hours
before air conditioner will turn off.
3. Press the plus or minus button to change delay time (0.5 to
24 hours).
4. Press TIMER again or wait 10 seconds. Timer indicator light
on air conditioner will remain on.
To set Timer to turn on air conditioner, changing the
previous settings:
1. Turn on air conditioner.
2. Adjust Mode to Cool, Heat (on some models), Fan Only, or
press POWER SAVER.
3. Adjust Fan Speed to Auto, Turbo, High or Low.
4. Adjust temperature between 66°F (19ºC) and 88°F (31ºC).
5. Wait 3 seconds before turning off air conditioner.
6. Press TIMER. Timer indicator light on air conditioner will
flash. Display on air conditioner will show remaining hours
before air conditioner will turn on.
Your new air conditioner is designed to give you many years of
dependable service. This section tells you how to clean and care
for your air conditioner properly. Call your local authorized dealer
for an annual checkup. Remember... the cost of this service call
is your responsibility.

Cleaning the Air Filter

The air filter is removable for easy cleaning. A clean filter helps
remove dust, lint, and other particles from the air and is important
for best cooling and operating efficiency. Check the filter every
2 weeks to see whether it needs cleaning.
NOTE: Do not operate the air conditioner without the filter in
place.
1. Turn off air conditioner.
2. Grasp air filter at tabs. Slide air filter up and out of filter slot.
12
7. Press the plus or minus button to change delay time (0.5 to
8. Press TIMER again or wait 10 seconds. Timer indicator light
Use the tabs to direct the air up, down, right, left or straight
ahead.
When your air conditioner is operating normally, you may hear
sounds such as:

AIR CONDITIONER CARE

3. Use a vacuum cleaner to clean air filter. If air filter is very dirty,
4. Slide air filter down into filter slot.
24 hours).
on air conditioner will remain on.

Changing Air Direction

Normal Sounds

Droplets of water hitting the condenser, causing a pinging or
clicking sound. The water droplets help cool the condenser.
Air movement from the fan.
Clicks from the thermostat cycle.
Vibrations or noise due to poor wall or window construction.
A high-pitched hum or pulsating noise caused by the modern
high-efficiency compressor cycling on and off.
wash it in warm water with mild detergent. Do not wash air
filter in the dishwasher or use any chemical cleaners.
NOTE: Air dry filter completely before replacing to ensure
maximum efficiency.