EN
The device is not designed to be operated with an external timer
■
or a separate remote control system.
The device should always be unplugged from the power supply if
■
it is not supervised and before assembly, disassembly or cleaning.
For your own safety, always check the device for damages prior
■
to using it. Only use the device if the device, mains cord and the
plug do not exhibit any damages!
If the device, the connecting cable or the plug of the device is
■
damaged, it must be replaced by the manufacturer or customer
service department or a similarly qualifi ed person (e. g. specialist
workshop) in order to avoid any hazards.
ATTENTION: Note cleaning instructions in "Cleaning and Stor-
■
age" chapter!
Risks of injury
■
Risk of injury and suffocation! Keep the device and packaging material away
from children and animals.
■
Danger of scalding from hot steam! Keep your hands and head away from the
ventilation slots. Hot steam emerges from the ventilation slots!
■
Danger of scalding from heat, hot steam or condensation! We recommend us-
ing oven cloths or kitchen gloves if you want to remove food.
■
Make sure that the connected mains cord does not present a trip hazard. The mains
cord must not hang down from the surface on which the device is placed in order to
prevent the device from being pulled down.
■
The device must not be moved during operation.
Risk of electric shock
■
Only connect the device to a properly installed socket with protective earth contacts.
The socket must also be easily accessible after connecting so that the mains con-
nection can be quickly disconnected. The mains voltage must correspond to the
technical data of the device. Only use proper extension cords, whose technical data
correspond to those of the device.
■
Never immerse the device, the mains cord and the plug in water or other liquids and
make sure that there is no risk of them falling in water or getting wet.
■
If the device falls in water, immediately disconnect the power supply. Do not attempt
to pull the device out of the water when it is connected to the mains supply!
■
Never touch the device, the mains cord and the plug with wet hands when these com-
ponents are connected to the mains supply.
■
Position the mains cord in such a way that it does not become squashed or bent and
does not come into contact with hot surfaces.
26