Programming Sequence - Erreka VIVO-M203 Manuel De L'installateur

3

PROGRAMMING SEQUENCE

General navigation through the programming parameters and menus
Display
?
ENTER
á
or
ESC
à
CL

It is necessary to close the gate or disconnect and
reconnect the control board in order to access the
programming menus.

Press the ENTER button to access the programming
menus. The display shows "C" flashing.

The ^ and keys can be used to select the required
V
values, which should be confirmed by pressing
ENTER. Pressing ENTER will confirm the value and
move onto the next display.

Use ESC to go back to the previous display.

To leave the programming menu, press ESC several
times until the display shows CL.
Checking turning direction
D1
ENTER
á
C
ESC
à
Select the value
using ^ and
V
ST2
ST1
O239A
STARTING UP AND PROGRAMMING
D2
ENTER
á
1
ENTER
(confirming)
à
Select the value
using ^ and
ESC
V
(unconfirmed)
à
All the programmable functions are organised in four menus,
which must be programmed in the following order:
1 Initial Conditions menu (D1=C, page 80), where
the installation characteristics are defined (number
of operators, turning direction, etc).
2 Programming menu (D1=P, page
programme the radio codes and the gate open/
close.
3 Main Functions menu (D1=F, page 84), to select
operation mode, standby time and pedestrian
opening.
4 Advanced Functions menu (D1=A, page 85).
Operator A1 turning direction is checked using
parameter C1 and pushbuttons ST1 (open) and ST2
(close): when the display shows C101, with the first 1
flashing, press ST1 / ST2 to check turning direction.
A2 turning direction is checked in a similar manner,
using C201.

For further information, and to see how to change
turning direction, see parameters C1 and C2 in page
80.
D3 - D4
0 X
Select the value using
^ and
V
82), to
Control board VIVO-M203(M)
79