Start-Up; Final Checks; User Instruction - Erreka VIVO-M203 Manuel De L'installateur

5

START-UP

Final checks

Following installation and programming, start up the
system and check the devices installed.
1 Check the correct working of the key devices
(pushbutton and wall key, radio control).
2 Check the correct operation of the safety devices
(photocells-safety strips).
3 Place an obstacle and make the gate collide with it
in order to check operation in the event of collision.

If the system does not work correctly, find out
why and put it
"Troubleshooting" on page 89).
right (see section
STARTING UP AND PROGRAMMING
Maximum force adjustment (parameter A6)

In operators without encoder or limit switches,
it is essential to adjust maximum force (A6) in
accordance with the weight and size of the
door or gate. Failure to do this will mean the
control board cannot recognise any stopping of
the gate (during operation programming,
when resetting, when colliding with an
obstacle, etc), and voltage will still be sent to
the operator even though the gate is stopped,
with the subsequent risk of accident and
failure.

User instruction

1 Instruct the user with regards to the use and
maintenance of the facility and provide him/her with
the instructions on use.
2 Signpost the gate,
automatically and indicating how to operate it
manually. Where appropriate,
operation is using the radio transmitter.
showing that it opens
indicate that
Control board VIVO-M203(M)
87