Total Open/Close Programming; Pedestrian Open/Close Programming - Erreka VIVO-M201 Guide Rapide D'installation Et Programmation

Masquer les pouces Voir aussi pour VIVO-M201:

Guide rapide d'installation et programmation (4 pages)

Manuel de l'installateur (106 pages)

Table Des Matières

Table des Matières

Les langues disponibles

Total opening radio code programming (with RSD receiver only)



If a receiver other than RSD is used,

see the corresponding instructions.

1 Connect

the

electrical

supply and close the leaves, keeping

PUL1 pressed down.

2 Select the code in the transmitter.



If a single operator is used (A1), the three strokes of ST1 corresponding to step 6 must be

carried out quickly in order to keep the corresponding A2 times to a minimum. Similarly,

the three strokes of ST1 corresponding to steps 7, 8 and 9 must be carried out quickly.

1 Connect the electrical

power supply and close the

leaves,

keeping

PUL1

pressed down.

2 Place DIP1 in ON, DIP2 in

ON, DIP5 in ON (only with

electrolock), DIP8 in ON

(soft stop)*.

S176B

DL3 lights up (programming

enabled).

3 Press

ST1

start

opening leaf 1.

*: If hydraulic operators with absorbers are used, soft stop is carried out mechanically by the operator (DIP8 = OFF)

This is carried out in the same way as total open/close

programming, with the following differences:

3 Place the DIPs as shown in the

figure (DIP1=ON, DIP4=ON). DL3

lights up to show programming mode

enabled.

power

4 Press the button of the required

channel.

DL2

programming is complete.