Erreka VIVO-M203 Manuel De L'installateur page 79

Connection of safety transmitter-receiver photocells in closing* (S.CIE-FT1)
P13 P14 P15 P16
P1 P2 P3 P1 P2 P3 P4 P5 P6
Connection of safety transmitter-receiver photocells in opening* (S.APE-FT2)
P13 P14 P15 P16
P1 P2 P3 P4 P5 P6 P4 P5 P6
P17 P18 P19 P20 P21 P22 P23
-FT
AUX
(Test)
24 Vdc
ENCODER1
ENCODER2
P7 P8 P9 P10 P11 P12
P239I
P17 P18 P19 P20 P21 P22 P23
-FT
AUX
(Test)
24 Vdc
ENCODER1 ENCODER2
P7 P8 P9 P10 P11 P12
P239J
* : in swing gates, S.CIE (C5) refers to the exterior
photocell.

We recommend installing interior and exterior
photocells.
1 Complete the connections as shown in the figure.
2 Duly programme the control board:

Closing photocells with pre-testing: C511

Closing photocells without pre-testing: C510

Without closing photocells: C500

For further details on programming, see "Starting
up and programming" on page 77.
* : in swing gates, S.APE (C4) refers to the interior
photocell.

We recommend installing interior and exterior
photocells.
1 Complete the connections as shown in the figure.
2 Duly programme the control board:

Opening photocells with pre-testing: C411

Opening photocells without pre-testing: C410

Without opening photocells: C400

For further details on programming, see "Starting
up and programming" on page 77.
INSTALLATION
Control board VIVO-M203(M)
75