Erreka VIVO-M203 Manuel De L'installateur page 86

STARTING UP AND PROGRAMMING
Gate open/close programming ("P3")
D1 D2 D3 D4
P 3 O ç

Before programming the run, adjust the
maximum force in accordance with the weight
and size of the gate (see "Maximum force
adjustment (parameter A6)" on page 87).
Failure to do so will mean the control board
cannot correctly detect any stopping of the
gate.
O
Before programming the gate open/close, ensure
the turning direction of the operator is correct
(see "Initial Conditions Programming (D1= "C")"
on page 80).
1
2
3
4
5
82
Installation Guide
G a t e r u n p r o g r a m m i n g , i n
a c c o r d a n c e w i t h
configuration of CA
Press ENTER to access the
programming menus. The
display lights up and D1
flashes.
Press the buttons ^ and
D1 shows the letter P flashing.
Press ENTER to confirm. D2
flashes.
Press the buttons ^ and
u n t i l t h e r e q u i r e d D 2
parameter appears (D2=3).
Press ENTER.
6 With encoder and/or obstacle detection without
slowdown, the gate carries out the approach
operation (opening for 4 seconds and then closing
t h e
to programme the closing point). It also carries out
slowdown in accordance with the AC value.
In other cases, close the gate before starting
programming.
7

The procedure with a twin-leaf swing gate is shown
below. Proceed in the same manner for sliding gates
or up-and-over doors.
8
9
until
V
10
V
11
12
Finally Oç flashes in the
display.
Start opening of leaf 1
by pressing ST1.
U241G
P r e s s S T 1 t o s t a r t
slowdown of leaf 1 in
o p e n i n g ( o n l y
s l o w d o w n
p r o g r a m m e d , C A 0 1 ,
U141I
CA02).
Finish opening of leaf 1
by pressing ST1. In any
case, this is carried out
automatically when the
U241J opening stopper (with
C701, C703, C704 or
C705) or the FCA (with
C 7 0 2 o r C 7 0 4 )
reached.
Start opening of leaf 2
by pressing ST1.
U141K
P r e s s S T 1 t o s t a r t
slowdown of leaf 2 in
o p e n i n g ( o n l y
s l o w d o w n
p r o g r a m m e d , C A 0 1 ,
U141L
CA02).
i f
i s
i s
i f
i s