Transport And Storage; Disposal And Environmental Protection; Markings - Tractel Guard trac Manuel D'installation, D'emploi Et D'entretien

11. Transport and storage

The guard trac™ or guard trac™ plus guard-
rail covered by this manual must be stored and
transported in its original package. During stor-
age and transport, this guard trac™ or guard
trac™ plus guardrail must be:
GB
The scrapping of the guard trac™ or guard trac™ plus guardrail must be carried out in accordance
with the legislation of the country.
The guard trac™ or guard trac™ plus guardrail must be treated as shown in the table below:
Component or Subset:
Single or double counterweight bracket
Single or double bracket
Clamping wedge
Wedge spring
Anti-slip pad
Latch
Barrier
Adjustable barrier
Barrier components
Pin
Adjustable gate
Structure
Small components
Counterweights
Counterweight Interface
Inter-barrier clamp
Seven markings are present on guard trac™
and guard trac™ plus guardrails:
1. The marking of single and double brackets
2. The marking of the latch, the wedge and the
anti-slip pad
22

12. Disposal and environmental protection

13. Markings

1. Store in dry place.
2. Store at a temperature between -30 °C and
+50 °C.
3. Protected against chemical, mechanical and
any other environmental contamination.
To treat as waste of the type:
Cast iron
Plastic
Stainless steel
EPDM
Stainless steel
Aluminium
Aluminium
Steel
Aluminium
Plastic and stainless steel
Loaded and reinforced concrete
Aluminium
Steel
3. Marking of barriers, adjustable barriers and
adjustable gate
4. The marking of the counterweight.
5. The marking of the counterweight interface
6. The marking of the inter-barrier clamp
7. The identification marking of the installation