Safety Device Failure; Technical Data - SOMFY DEXXO SMART io Manuel D'installation

EN

11.2. Safety device failure

In the event of a malfunction of the photoelectric cells or the gate contact,
a key contact connected between terminals 12 and 13 allows the door to
be controlled in dead-man mode a er 3 minutes.

12. TECHNICAL DATA

GENERAL SPECIFICATIONS
Power supply
Max. power consumption
Programming interface
Climatic operating conditions
Radio frequency
Number of memorisable channels:
One-way controls (Keygo io, Situo io,
etc.)
CONNECTIONS
Programmable Type
safety input Compatibility
Wired control input
Offset lighting output
Orange light output
Controlled 24 V power supply output
Accessories power supply output
Offset antenna input
Backup battery input
OPERATION
Forced operating mode
Independent remote lighting control
Timed lighting (a er movement)
Automatic closure mode
Orange light warning
Partial opening control
Gradual starting
Closing slowdown zone
10
220-230 V - 50/60 Hz
600 W (with offset lighting,
500 W)
4 buttons - 12 indicator lights
- 20°C/+ 60°C - IP 20
868 - 870 MHz
< 25 mW
Total/partial opening control :30
Auxiliary output control: 4
Integrated lighting control: 4
Dry contact: TX/EX photoelectric
cells - Bus cells - Reflex cell
Dry contact: NO
Dry contact
Max. 230 V - 500 W
• either 5 fluocompact or LED
lights
• or 2 power supplies for
low-voltage LEDs
• or 1 halogen light, max. 500 W
24 V - 15 W
Yes: for possible TX/RX photo-
electric cells auto-test
Max. 24 V - 400 mA
Yes: compatible with io antenna
(ref. 9013953)
Yes: compatible with 9.6 V battery
(part no. 9001001)
Battery life: 24 hours; 3 cycles
depending on door
Charging time: 48 hours
By pressing the "+" and
"-" buttons before auto-
programming
Yes
60 s
Yes: short or long closure
time-delay
2 s in sequential mode with
closure time-delay
Yes
Yes (only for radio control)
Programmable: 3 values possible
DEXXO SMART io
©
Copyright 2018 SOMFY ACTIVITES SA. All rights reserved.