Connections; Safety Notes - Monacor TFT-800LED Mode D'emploi

Function of the buttons
Switching between video sources:
Source
AV PC / V GA
Functions for the OSD menu:
– to call up the menu page selected
– when a menu item has been selected:
to call up a setting scale, to select one
of multiple options, to call up a sub-
menu page, to activate a function or to
display information
Deactivating on-screen displays
Menu
OK
Functions for the OSD menu:
– to call up the menu
– to return to the higher menu level
– to exit the menu
Information on source is briefly displayed
Display
in the top left corner of the picture
Sleep function (automatic switchover to
Sleep standby after a time defined)
to define the time (in minutes):
0 15
(= off)
All other buttons of the remote control are without function
for this monitor .
2 Infrared sensor for the remote control signals
3 Power LED
LED off: monitor on standby
LED green: monitor switched on
LED red: no video signal (
4 Control buttons on the monitor
corresponds to
correspond to
corresponds to
corresponds to
corresponds to
HD
30 45 60
☞ chapter 6 .2)
on the
remote control
on the
remote control
on the
Item
remote control
on the
Menu
OK
remote control
on the
Source
remote control

1.2 Connections

5 Power supply jack to connect the power supply
unit provided
6 Input FULL HD (HDMI
7 Input VGA (Sub-D connector)
8 Input VIDEO (BNC connector) for a composite
video signal
9 Input AUDIO (3 .5 mm jack) for audio connec-
tion of the source at the VIDEO input or VGA
input
10 USB port; for service only!
2

Safety Notes

The units (monitor and power supply unit) corre-
spond to all relevant directives of the EU and are
therefore marked with
WARNUNG The power supply unit uses danger-
ous mains voltage . Leave servicing
to skilled personnel only . Inexpert
handling may result in electric
shock .
•
The units are suitable for indoor use only . Pro-
tect them against dripping water, splash water
and high air humidity . The admissible ambient
temperature range is 0 – 40 °C .
•
Do not place any vessel filled with liquid on the
units, e . g . a drinking glass .
•
Always place the monitor so that sufficient air
circulation is ensured during operation . Never
cover the air vents .
•
Immediately disconnect the power supply unit
from the mains socket
1 . if the monitor or the power supply unit is
visibly damaged,
2 . if a defect might have occurred after a unit
was dropped or suffered a similar accident,
3 . if malfunctions occur .
In any case, the units must be repaired by skilled
personnel .
•
For cleaning the power supply unit, only use a
dry, soft cloth . For cleaning the monitor, use a
soft cloth which may be slightly wet, if required .
Never use chemicals or aggressive detergents .
Always disconnect the power supply unit before
cleaning .
•
No guarantee claims for the units and no liability
for any resulting personal damage or material
damage will be accepted if the units are used for
connector, type A)
TM
.
13