Fault And Troubleshooting - Matrix Stanley 4 in 1 Garden tool Traduction Des Instructions Originales

G
B

11. Fault and troubleshooting

Fault
The engine does not
start
Engine starts and dies
Motor starts. However
the cutting tool stops
Device works
with interruptions
(compression)
Smoke emission
Device does not work
with full power
The brush cutter works
not with full power
46
Possible cause
air filter it is dirty
-
- Fuel filter clogged
Lack of fuel supply
-
Error in the fuel line
-
- Starting device is defective
- Engine flooded
Spark plug not inserted
-
No ignition spark
-
- Motor defective
- Carburettor defective
- Incorrect carburettor setting (Idle speed)
- Cutting tool is blocked
-Internal error (Drive shaft, transmission)
-Clutch defective
The carburettor is set incorrectly
-
Spark plug is sooted
-
On/Off switch defective
-
- Incorrect fuel mixture
- The carburettor is set incorrectly
The machine is overloaded
-
The air filter is dirty
-
The carburettor is set incorrectly
-
- Silencer blocked
Cutting blade is blunt or damaged
-
- Silage too high (device
overload)
Troubleshooting
Clean/replace air filter
-
- Clean or replace the fuel filter
Refuelling.
-
Check fuel line for bends or damage
-
- Contact the service centre.
- Remove, clean and dry the ignition
spark plug;
Subsequently pull the starter rope several
times; re-install the ignition spark plug
- Check the ignition spark plug connector
for correct setting
- Clean or replace ignition spark plug
Check the ignition cable for damage
-
Contact the service centre
-
- Contact the service centre
- Contact Service Center
Turn off the engine and
-
remove the object
- Contact the service centre
- Contact the service centre
Contact the service centre
-
Clean or replace the spark plug
-
Contact the service centre
-
-Use two-stroke mixture in the mixing
ratio 40:1
- Contact Service Centre
-While mowing/trimming do not press
with force.
Clean or replace air filter
-
Contact the service centre
-
- Check the exhaust
Sharpen the cutting blade or get it
-
replaced
Cut grass gradually
-