Matrix Stanley 4 in 1 Garden tool Traduction Des Instructions Originales page 9

Do not smoke while refuelling or operating
the device.
Wipe off dry the petrol that possibly spill.
Start the device only at a location remote location from
the area of refuelling.
Make sure that the lid of the tank-container is always
well closed. Look for any leaks.
While the engine is running or in case the machine
is hot, the fuel tank cap should not be opened or fuel
should not be refilled.
Slowly open the filler cap so that petrol vapors can
escape.
Make sure that the handles are dry, clean and free of
gasoline mixture.
Do not use the device without and correctly installed
exhaust guard.
Do not touch the exhaust. Risk of burns.
Use only the fuel recommended in the manual.
Keep gasoline only in containers designated for it in a
safe place.
Caution: Petrol and oil can leak in the case of incorrect
use, improper storage or defect. Take precautions, as to
how you can prevent environmental damage in such a
case. Oil and petrol can for example be vacuumed with
special binders.
In the event of a fire, use the CO2 extinguisher to
smother the flames. Also foam, powder or sand are
suitable for extinguishing small fires. Never extinguish
fires due to petrol and oil with water. Danger of
explosion!
In case of emergency, please contact your fire
department!
While cutting on a slope, please stand always below the
cutting tool.
Always make sure that there are no objects etc. collect
in the cord head, in the protective cover or in the engine.
Do not use a wire or similar things in the running-spool.
Work only in daylight or good artificial light.
Check before each use of the device and its components
and protective devices for damage or wear and make
the necessary repairs if required. Never disable safety
devices
Do not use the appliance if damage or wear and tear
should come to light.
Keep the tools clean and operative, in order to be able to
work better and safer.
Always hold the device at a sufficient distance from the
body when working.
During work breaks and change of location, always turn
off device, wait for the standstill of the cutting tool and
shut off engine.
Never leave the appliance unattended at the workplace.
Store the device during work breaks in a safe place.
While working with this device, do not get distracted. As
a result of that, you could lose control of the device.
Never use the device in the rain, in a damp or wet
environment and do not store it outdoors.
If the device gets wet, wait until it is completely dry
before you use it again.
Search for foreign objects in the working area before
working with this device and remove them. If you
encounter a foreign object despite this while cutting,
switch off the device and remove it.
In the event of a blockage by foreign objects (stone,
collection of grass), switch off the appliance and remove
it with a blunt object. Never remove debris stuck with
your fingers as this could cause serious injury.
The running device must be implicitly kept away from
your body.
Do not overload the machine and do not do any work for
which the appliance is not intended.
Make sure that the ventilation openings are always free
of dirt.
Keep the device out of the reach of children.
G
B
9