Cleaning, Maintenance , Transport And Storage; Regular Checks - Matrix Stanley 4 in 1 Garden tool Traduction Des Instructions Originales

G
B
9. Cleaning, maintenance , transport and
storage
RISK OF INJURY
ATTENTION: For all work performed
on and for cutting tools, always wear
protective gloves.
To reduce the risk of unintentional start-
up, pull out the spark plug connector.
9.1 Cleaning
Use a damp cloth for cleaning the plastic parts. Do not
use detergents, solvents or sharp objects.
Depending on technical factors, during the course of the
work, wet grass and weeds grow around the drive axle
under the cutting guard.
Remove them, since otherwise the engine will be
overheated due to high friction.
9.2 Maintenance

9.2.1 Regular checks

Please note that the following information refer to a
normal usage. Under certain circumstances (longer daily
work, strong dust pollution, etc.) shorten the specified
intervals accordingly.
Prior to commencing work and after each tank filling:
Check for loose attachments especially at the cutting
equipment and shoulder strap, fuel leakage and
damaged parts such as cracks in the cutting assembly
(visual inspection).
Perform visual inspection also after every time the
device falls down and also for other impacts, to detect
significant defects.
Weekly inspection: Gearbox lubrication (also as per
requirement).
If required: Tighten accessible mounting bolts and nuts.
You will avoid excessive wear and damage to the device,
30
if you adhere to the specifications of this instructions
manual.
For all damages caused by failure to observe the
instructions given in this operating manual, the user is
responsible.
This also applies for non-authorized changes on the
device, use of non-authorized replacement parts,
attachment parts, work tools, unrelated use and usages
not as per intended purpose, consequential damages
due to use of defective components.
Hold the device as well as all cutting equipment and
protection system always in good operating condition.