Air Filter Cleaning - Matrix Stanley 4 in 1 Garden tool Traduction Des Instructions Originales

G
B
9.2.4 Bobbin change
19
ON
A27

9.2.5 Air Filter Cleaning

A28
32
- Pull the bobbin cover by vigorously pressing the retaining
tabs of the bobbin (19)
- Move the coil cover in the "Off" position. Remove the
coil with the pieces of thread and the pressure spring.
OFF
- Remove the used coil.
- Take the new bobbin and pull out 10 cm of both threads
respectively.
- Now insert the bobbin (19) on the tapered spring and
lead both threads respectively through the eyelets on the
housing of the spool of thread.
- Now place the spool cover on the new bobbin. Turn it so
that the recesses of the spool cover match with the loops
in the thread spool housing.
- Now press the coil cover together with the thread spool
15
until it snaps into place in the thread housing. Then bring
the coil cover in the "On" position. Through the blade in
the cutting guard (15), the trim thread is shortened to the
correct length, if the machine starts up again.
19
After prolonged operation you should clean the air filter (5).
Dust and pollen clog the pores of the foam filter.
- Remove the cover (J) and wash the filter (K), in slightly
j
soapy water. Caution: Do not use gasoline or solvents.
- Dry the filter before you put it back. In order not to
shorten the life of the engine, a damaged air filter must
be replaced immediately.
k