Working With The Pruner - Matrix Stanley 4 in 1 Garden tool Traduction Des Instructions Originales

- To comb through young stocks of trees and for cutting
grass, hold the device such as a string trimmer close to
the ground.
ATTENTION: Incorrect use and abuse can damage the
cutter blade and cause serious injury through the parts
that are hurled down.
- To reduce the risk of accident due to the cutter blade,
note the following points:
- Never cut shrubs or wood with more than 2 cm in
diameter
- Avoid contact with the metal bodies, stones, etc.
- Check the cutter blade regularly for damage. Never use
damaged cutter blade again.
- If the cutter blade is noticeably dulled, it must
be sharpened by a qualified specialist, as per the
specifications. In case of noticeable imbalance, the
cutter blade must be replaced.
7.3 Trim-line Automatic
The Petrol-brush cutter is delivered with a full spool
holder.
The thread becomes worn out during the work. So that
new thread is supplied, press the shutter release at the
spool holder vigorously on the ground, with the engine
running.
The thread is automatically released by the centrifugal
force. Through the blade at the cutting guard, the trim
thread is shortened on the correct length.

8. Working with the pruner

A20
A21
A22
8.1 Precaution measures for the sawing procedure
So that the injury or accident risk is reduced as far as
possible, it is important to be sufficiently informed
about the sawing procedures as well as about the
precautionary measures for accident prevention.
Therefore please read the following information carefully
and note the safety instructions in Chapter 2 also during
your entire operation without fail:
A23
G
B
27