Matrix Stanley 4 in 1 Garden tool Traduction Des Instructions Originales page 16

G
B
15
10
26
A7
16
- Attach the cutting guard (15) with the 4 screws
on the retaining device on the shank (if not
already fitted). In addition, the protective cover
must be fitted with the blade at the cutting guard.
- Lock the shaft of the brush cutter at the required
position with a screwdriver or with the Allen key
(28).
- Loose with the spark plug wrench (29) the
locknut for the blade (14), by turning in a
clockwise direction (if already installed).
- Remove the hexagon nut (14), the clamping
flange (13) and the retaining plate (16) for the
thicket of knives. Keep these parts sage.
- Leave the support flange (17) on the shaft.
- Lock the shaft of the brush cutter at the required
position with a screwdriver or with the supplied
Hex Key (28).
- Rotate the thread spool (19) against the
clockwise on the shaft.
ATTENTION: Left hand thread
Connect the drive unit and assembly:
Put the ends of the modules to be connected
into one another. While doing so, make sure that
the lock pin (26) is snapped in place. Check by a
pulling apart by way of trial. Fold down the (26a)
cover and secure the modules by tightening the
locking screw (10).
Release of the drive unit and assembly:
Release the locking screw (10). The cover (26a)
jumps back. Hold the locking pin (26)found below
the cover pressed down and and at the same
time release the modules from one another by
carefully pull apart.
26a