Matrix Stanley 4 in 1 Garden tool Traduction Des Instructions Originales page 23

5.7 Mounting Trolley System
Module 7
A13
9
2
9
b
2
c
Mounting
Checks before use:
Distance from the shoulder strap suspension up to
the cutting tool min. 750mm
Distance of the cutter from the floor, while using as
trimmer 0-300mm and while using with cutter blade
100- 300mm. The fuel tank should be filled up to the
half with the two-stroke petrol in the mixture ratio
of 40:1.
Keep a safe distance between yourself and the
cutting tool while working.
The Petrol-brush cutter/trimmer/ pruner unit must be
used with the shoulder strap
(9). Balance out the machine first at the switched-off
state.
- Put on the shoulder strap (9).
- Adjust the strap length in such a way that the snap
hook (b) is located in about a hand's width below the
right hip.
- Hang up the petrol-brush cutter at the snap hook.
- Let the machine swing.
The cutting tool may just about touch the ground
during normal work posture.
Hang the device with the running engine to the snap
hook (b) of the shoulder strap.
Secure-fit tab on the shoulder strap
ATTENTION! In the event of an emergency, the
secure-fit tab (C) can be pulled out at the shoulder
strap (9). The machine will then be immediately
released from the shoulder strap (9) and falls to the
floor.
G
B
23