Matrix Stanley 4 in 1 Garden tool Traduction Des Instructions Originales page 10

G
B
Store the appliance in a safe and dry place.
After an impact or other damages, check the machine for
damage.
Pay particular attention while trimming lawn edges,
gravel borders and similar places that stones and soil
could hurl away by the cutting line.
Never cross streets or roads with the device switched
on.
Never cut against hard objects such as stones, etc.
Thus you will prevent personal injury and damage to the
device.
Never use the device without protection device.
Never stop the cutter with your hands. Always wait until
it stops by itself.
Hold the cord head as close as possible to the ground.
Cut only grass that grows on the ground. Grass in wall
cracks or on stones may not be cut.
Always make sure that no objects etc. collect in the cord
head, in the protective cover or in the engine .
Operate the device only with protective device.
Always switch off the device before you turn it off.
Pay attention to risk of injury in the area of the cutting
device, which is used for cutting the thread.
Danger of kick-back! There is always kick-back hazard
if the cutting blade comes into contact with branches or
other objects. The brush cutter becomes uncontrollable
due to this and can pushed with great force in the
direction of the operator.
Do not use the device without and correctly installed
exhaust guard.
Do not touch the exhaust. Risk of burns.
Do not use a wire or similar things in the running-spool.
Never cut against hard objects such as stones, etc.
Thus you will prevent personal injury and damage to the
device.
Never use the device without protection device.
10
Always use only the original thread. Never use a metal
wire instead of the nylon thread.
The petrol-brush cutter is dependent on the mounted
cutting tool meant for trimming lawn or grass, for cutting
scrub, shrubs, bushes and young trees in the private
area.
The device must not be used for other purposes.
The manufacturer does not assume any liability in case
of Improper use as well as changes to the machine.
Please also note the safety instructions, the instructions
for installation and operation, as well as the other
generally applicable accident prevention regulations.
The appliance and the cutting tools must be regularly
and properly checked and maintained. Damages must be
repaired by a specialist workshop.
Use only accessories specified by the manufacturer.
Let your device repaired only by qualified personnel and
only with original spare parts. This is to ensure that the
safety of the device is maintained.
Make sure that the cutting tool is stopped when the
engine is idling.
Check this regularly and do not use the machine if
you detect a movement in the idle position. Bring the
machine to a specialist workshop for checking and and
repair. The setting of the idle speed should also be done
only in a professional workshop.
ATTENTION: The cutting tool rotates after the engine
has been shut off for a few seconds after that.
Put down the device only after the cutting tool has come
to a standstill and the engine has been shut off.
Replace a damaged cutting tool immediately with a new
one.
Always use only the original thread. Never use a metal
wire instead of the nylon thread.
The appliance and the cutting tools must be regularly
and properly checked and maintained. Damages must be
repaired by a specialist workshop.