Matrix Stanley 4 in 1 Garden tool Traduction Des Instructions Originales page 35

9.2.10 Trimline blade
A36
- If the trim thread is not cut clean any more while
lengthening, file the cutting edge with a file. File in one
direction and in the specified angle.
9.3 Transport
Remove the spark plug before transporting and empty
the oil tank as well as the petrol tank, to prevent leaking.
In order to prevent damage and/or injuries, also
remove the cutting equipment that was attached last
before every transport and store it in a transport guard
designated for it.
Clean and maintain the equipment before transport (see
above) and secure it against slipping.
For a longer transport it is recommended to dismantle
the extension (20) from the drive unit.
9.4 Storage / Winter
Clean and maintain the device before storing.
So that the brush cutter-grass trimmer- pruner-
combination device works after longer periods of storage
you should note the following:
- Drain the fuel tank (7) before storing.
- Start the engine and let it run until it comes to a
standstill.
- If the engine is cooled, remove the spark plug.
- Fill a small spoonful of 2-stroke mixture into the spark
plug hole and pull the wire rope hoist several times
slowly.
This will blow out the soot deposits and the piston and
cylinder will be lubricated.
- Keep the brush cutter-grass trimmer-pruner-
combination device in a dry place, out of the reach of
children and which does not have a fire-hazard.
9.4.1. Restart after longer work breaks
1. Check the spark plug, replace it if necessary and
screw it into the opening.
2. Pull the wire rope hoist several times quickly to clean
the engine room of oil and debris.
3. Fill the fuel tank with 2-stroke mixture 40:1. Start as
described in 5.1.
G
B
35