Matrix Stanley 4 in 1 Garden tool Traduction Des Instructions Originales page 18

G
B
10
26
Teil C
Teil B
18
- Lock the shaft of the brush cutter
at the intended location with a
screwdriver or with the hex key (28)
supplied.
- Turn the hex nut counter-clockwise to
the shaft and tighten with spark plug
26a
wrench (29).
ATTENTION: Left hand thread
Connecting the drive unit and
Assembly:
10
Plug in the ends of the connected
26a
modules together. Make sure that the
a
locking pin (26) snaps into place. Check
by pulling apart on a trial basis. Fold
26
down cover (26a) and secure assembly
by tightening the locking screw (10).
Release of the drive unit and
Assembly:
Release the locking screw (10).
The cover (26a) jumps back. Hold
the locking pin (26) under the cover
pressed down and at the same time
loosen the modules from one another
simultaneously by carefully pulling
apart.
The blade must be polished only by
suitably qualified and experienced
specialists.
Improperly polished blades increase
the risk of breakage and cracks.