Matrix Stanley 4 in 1 Garden tool Traduction Des Instructions Originales page 25

A16
6
A17
4
8
A18
Start with a warm engine
- Corresponds to the procedure as with cold engine. Choke lever is always in the "ON" position.
ON
A19
Press the primer (25) 6 times.
25
• Start the machine by controlled pulling on the cable (6).
• While doing so, press the device with the 2nd hand on
the floor.
ATTENTION: Never set foot on the shaft or kneel on it.
Now press the release mechanism (4) and then the
throttle lever (8) until the device is running smoothly and
has reached the full speed.
As soon as the device is running, the choke lever (24) can
be reset to the "ON" position again.
Switching off:
- Start the engine to return without gas to idle speed.
24
Set the operating switch (3) at the operating handle in the
Off-position "O".
ATTENTION: The cutting device continues to rotate
after switching off the engine for a few seconds.
Hold both handles tight up to complete standstill of
the cutting device.
G
B
25