Matrix Stanley 4 in 1 Garden tool Traduction Des Instructions Originales page 17

5.3 Brush cutter-grass trimmer-pruner-hedge cutter combination device: Brush cutter
RISK OF INJURY
ATTENTION: For all work performed on and for cutting tools, always wear gloves.
- Danger of backlash! There is always danger of backlash, if the blade tips come into contact
with branches or other objects. The brush cutter becomes uncontrollable due to this and can
pushed with great force in the direction of the operator.
Module 3
10
26a
26
15
28
15
A8
Mounting
To use the device as brush cutter, the
cutting guard and the cutter blade
have to be mounted. Do not remove
the cutting guard (15), if you replace
thread spool (19), or blade (11)
- Attach the cutting guard (15) with the
4 screws to the holding bracket at the
shank (if not already fitted). - Install
blade (11) as shown in Figures 1 to 6.
- Lock the shaft of the brush cutter
in the required position using a
screwdriver or with the hex key (28)
supplied.
- Turn the thread spool (19) in the
clockwise direction from the shaft (if
already installed).
- Leave the support flange (17) on the
shaft.
11
- Set the cutter blade (11) on the
support flange (inscription facing the
user).
- Place the clamping flange
(13) and the retaining plate (16) (note
orientation) on the cutter blade (11).
29
11
G
B
15
11
17