Tig Dc Welding; Select Welding Process; Start Mode - Cebora KINGSTAR 400 TS Manuel D'instruction

5 TIG DC WELDING�
TIG process not available with robot mode activated.
5�1

Select welding process:

To choose the welding process from those available select pushbutton DC - Fig� 10.
5�2

Start mode

To choose the start mode, select pushbutton DE - Fig� 10. Start modes are the same for all TIG processes.
The START pushbutton for manual applications is present on the wire feeder remote control connector�
2 stroke mode
4 stroke mode
3 level mode
4 level mode
3301256
Select the main process pushbutton TIG: the pushbutton turns
orange�
Select the relevant process from amongst those listed by turning
knob I and confirm by pressing I.
Start control pressed
Start control released
Mode appropriate for short welding bursts or automated robotised welding.
Welding is started by pressing the torch trigger and ends when the same is
released.
Appropriate mode and perform long-term welding. Starting and stopping
are controlled by pressing and releasing the torch trigger.
When the arc strikes, the current is set to the first level. As long as the torch
trigger is pressed, the current remains on the first level. Upon releasing the
torch trigger, the current passes from first to second level within the slope
time; once the second level is reached, this is maintained. In order to pass
to the third current level, simply press the torch trigger and the current is
adjusted to the third value selected within the set slope time. When the torch
trigger is released welding stops and the post-flow procedure is run.
When the torch trigger is pressed and released, the torch switches between
two preset levels as many times as the operator wishes. Welding stops
when the operator holds the torch trigger continually pressed for at least 1
second..
79/109