Connecting Cooling Unit Item No 1685 To Tig Power Source Item No 559 - Cebora ITACA GP73190-BIO Manuel D'instructions

In addition, there is a pressure switch on the delivery circuit
to safeguard the welding torch by monitoring the pressure of the coolant.
When a pressure drop occurs due to a lack of fluid or a blocked pump, the pressure switch reports the anomaly to the
power source and the power source automatically stops.
This anomaly is indicated on the power source display.
3.1

Connecting cooling unit Item No 1685 to TIG power source Item No 559

♦
Remove from the bottom of power source Item No 559, the 4 feet A, the 2 supports B and the cover C.
Arrange the cooling unit on a flat surface, position the TIG power source on top of the cooling unit so that the
4 metal tabs D on the unit engage with the 4 slots E on the bottom of the power source.
♦
Use the 4 screws F to secure the unit to the power source.
A B
C
12
A
D
B C
E
E
F
3301128/A