Mig Welding; Power Source-Wire Feeder Connection; Selecting The Synergistic Curve - Cebora KINGSTAR 400 TS Manuel D'instruction

4

MIG WELDING

4�1

Power source-wire feeder connection

Connect the earth cable to the socket L(-)�
Connect the power cable of the power source-wire feeder connection to rear socket N (+)�
Connect connector of power source-wire feeder service connection to rear connector M�
Connect the connectors for managing SRS Item No 443 (option) of the power source-wire feeder connection to rear
connectors O-Q.
Connect wire feeder Item No 5690133 (manual) or Item No 1648 (Robot, see instruction Item No 3301052) to the power
source via the power source-wire feeder connection Item No 2061
4�2

Selecting the synergistic curve:

Select the DC pushbutton or access the submenu using pushbutton DI (see Fig 10)
3301256
Select the Material
Select the wire type
Select wire diameter
Select the gas type
Select the welding process
Use pushbutton I (Fig. 7) to select the welding process from
among those available based on the previous selections,
confi rmed by pressing the knob I.
73/109