Preparing The Electrode; Mma Dc Welding - Cebora 553 Manuel D'instructions

5.8.1

Preparing the electrode

6

MMA DC WELDING

This welding machine is suitable for welding all types of electrodes, with the exception of cellulosic (AWS 6010).
♦ Make sure that the G switch is in position 0, then connect the welding cables, observing the polarity re-
quired by the manufacturer of the electrodes you will be using; also connect the clamp of the ground ca-
ble to the workpiece, as close to the weld as possible, making sure that there is good electrical contact.
♦ Do not touch the torch or the electrode holder and the earth clamp simultaneously.
♦ Turn on the machine using the G switch.
♦ Select MMA process.
♦ Adjust the current based on the electrode diameter, welding position and type of weld to be made.
♦ Always remember to shut off the machine and remove the electrode from the clamp after welding.
Beware of electrical shocks
When the main switch is in ON position, the electrode and the non-insulated part of the electrode holder are live.
Therefore, make sure that the electrode and the non-insulated part of the electrode holder do not come into contact
with electrically conductive or earthed persons or components (e.g. outer casing, etc.).
To select this process, see section 5.1.
To modify the welding parameters, proceed as follows:
72/89
WARNING
Turn knob B to change the welding current.
3301230/A