Maintenance - Rizzoli TE 60 Manuel D'utilisation

4

MAINTENANCE

4.1 CLEANING
The stove works better if all its parts are without
combustion residuals, a clean stove will be less
exposed to problems due to wear. Cleaning fre-
WARNING! All these operations must be done with cold stove.
4.2 CLEANING THE VISIBLE PARTS
For painted parts, do not use abrasive or aggres-
sive solution and in case of stains pour some oil
and wait while it absorbs the halo, then clean with
4.3 GRILL CLEANING
Every time you use the stove you have to clean
the wood carrying grill before, at least you have
to clean the more rough deposits: the holes of the
grill should not be obstructed. To make this you
can use the poker given together with the stove. If
4.4 ASH BOX
Every time you use the stove you have to check
the ash box located under the combustion cham-
ber. When the box is full, you have to empty it.
If you do not empty it, the ash accumulates itself
4.5 FUME-CIRCUIT INSPECTION
Cleaning the fume circuit inside the stove must be
done when necessary in correspondence with the
chimney cleaning. With the cleaning, all the depos-
its of ash and soot are removed. For this reason, it
is necessary to use a vacuum cleaner with flexible
handle and also terminal small and handy, in order
to access easily inside the device. To do this, it is
necessary to unfix the chimney connection and
quency depends on how much and how the stove
is used, as well as on combustible quality.
a soft rag. It is also recommended to avoid the use
of solvents or denatured alcohol on painted parts.
the grill is not well cleaned, the flame could not be
well feed and so you could experience an irregular
combustion. If the grill is being removed, it must
be placed in its housing with the flat part turned
upwards.
and makes the cleaning more difficult. In case of
excessive cinders the flame could not be well fed
and you could experience an irregular combustion.
then starting with the cleaning from the top. For
an even more accurate cleaning, you have to re-
move the cap of the stove and with a star screw-
driver remove the fixing screws of the panel placed
in the upper part of the device. Once the cleaning
process is finished, repeat the same operation in
the opposite way.
57