First Lighting - Rizzoli TE 60 Manuel D'utilisation

2.10

FIRST LIGHTING

Before starting to use the stove, remove the pack-
aging materials and the stickers placed on the
device. It is suggested to make a first lighting of
the stove just to verify the correct installation. The
2.11 GLASS CLEANING AIR REGULATION
The inflow of air for glass cleaning is regulated by a
valve ruled by a lever located below the panoram-
ic door. The valve is closed in the right position,
open in the left position. If the stove is installed in
a chimney with high draught, you could experience
an excessive air inflow. In this case it is necessary
Picture 10 – Glass cleaning air regulation
2.12 SETTLEMENTS
All the refractory materials inside the stove experi-
ence a settlement process that may generate small
holes on the bricks, such holes do not preclude an-
yway the working of the stove.
Other settlements may involve other parts of the
first lighting must be done with moderate fire, us-
ing little wood broken in small pieces. In the next
lightings you can progressively increase the load
of combustible.
to narrow partially the air passage in order to com-
pensate the excessive draught. Usually, this regu-
lation must be done, when necessary, only during
the installation. It is recommended not to obstruct
totally the air passage because this could cause an
irregular working that could dirty the glass.
stove so during the heating and cooling phases
you might hear light noises. These symptoms do
not absolutely preclude the use of the stove and
fade out till disappearance with the constant use
of the stove.
53